1.480.588.8185
Specializing in MG TABC Parts 1.480.588.8185
Hub ONLY, tapered rear axle, left side Use with CH236 axle.
Shaft ONLY, rear axle, tapered, FREE assembly of hub and half shaft when purchased together.
Shackle pin: chassis frame, lower rear pin
Shackle pin, length 2.75",upper pin rear spring
Shock, front left TC, Core charge $250
Shock, front right TC, Core charge $250
Shock, rear left TC, Core charge $250
Shock, rear right TC, Core charge $250
Rebuild Kit, Luvax Shocks *** SPECIAL NOTE: Modern lip seal fits most shocks. OD = 1.308"
Shock link, TABC front, 5 3/4" (ctr. to ctr.)
Shock link, TABC rear, 4" (ctr. to ctr.)
Shackle Plate, Front spring, rear shackle
Shackle pins, front springs, 3.25" long
Sealed bearing conversion kit, front axle stubs
Washer, dished w/holes, install concave.
Steering knuckle, R/H, ORIGINAL (magnafluxed) w/new king pin bushings, Core charge $150
Steering knuckle, L/H, ORIGINAL (magnafluxed) w/new king pin bushings, Core charge $150
Steering knuckle, R/H, REMANUFACTURED w/ new stub axle & king pin bushings, Core charge $150
Steering knuckle, L/H, REMANUFACTURED w/ new stub axle & king pin bushings, Core charge $150
Stub axle insert, R/H, 5/8 BSF
Stub axle insert, L/H, 5/8 BSF
Cotter, tapered lock bolt & nut, set of 2
Bushing, King Pin, original type "wrapped" bushing
"Big Bore" Muffler, TATC, 1 3/8" outlet
"Big Bore" Tailpipe, TATC, 1 3/8
Stud, TABC exhaust, set of 3, length: 1 7/8"
"Big Bore" clamp, muffler to tailpipe.
Bracket, tailpipe frame 1 1/4"
"Big Bore" Bracket, tailpipeframe 1 3/8"
Steel sleeve, front wing brace bushings
Steel plate, side lamp/wing support
Type – F2 , loop diameter 3/8"
Type – N1, Slow running cable clip
Type – N2, Slow running anchor clip
Dome nut, gas tank strap to tub
Gas cap trigger release, "PRESS", TA TC 6000 (approximately)
Gas cap trigger release, "MG" > TC 6000 (approximately)
Lock & handle assembly, complete set